温馨提示：本站仅提供公开网络链接索引服务，不存储、不篡改任何第三方内容，所有内容版权归原作者所有
AI智能索引来源：http://www.mr2.com/forums/archive/index.php/t-65830.html
点击访问原文链接

Other how to remove valve cover [Archive] - Toyota MR2 Message Board

进入原网站 导航首页
Other how to remove valve cover [Archive] - Toyota MR2 Message Board Toyota MR2 Message Board > General and Racing Discussions > General Technical Discussion > Other how to remove valve cover PDA

View Full Version : Other how to remove valve cover


NaHPrO05-18-2011, 06:38 PMI have a oil leak out of my valve cover and was going to remove the valve cover and replace the gasket... i see no bolts or how to remove the valve cover... can somebody please tell me how? thanks... marazaii05-18-2011, 07:02 PMremove the spark plug wires and remove the big looking nuts, you can use an adjustable or a #30mm socket or wrench. MidshipMan07-12-2011, 11:12 AMHey man,

I'd like to add that you should ensure to number the ignition wires so that you know which order they go in after you re-install them. Sometimes you have to tap the cover gently with a rubber mallet to loosen it up. If you need a more demonstrative picture of what bolts to remove then you can refer to this diagram (http://www.utoyot8.com/Picture.aspx?ccId=139188600&ppId=432130723&ppInfo=(9001-9311)5SFE&ccode=&ppName=) that I found on toyotapartszone.com.

Remember to clean any surfaces that are exposed before you install the new gasket set! :) Powered by vBulletin® Version 4.2.5 Copyright © 2026 vBulletin Solutions Inc. All rights reserved.

智能索引记录